Author Topic: Serial settings for TS-RX4.0TL/R5?  (Read 174 times)

bmel

  • Calf
  • *
  • Posts: 3
Serial settings for TS-RX4.0TL/R5?
« on: September 24, 2019, 06:02:14 pm »
Hi, sorry if this has already been posted but I couldn't find an answer anywhere. I'm trying to use a DB9 cable to connect to my TS-RX4.0TL/R5 I've tried using a few of the common BAUD rates that I know us but was unsuccessful. I googled 'common baud rates' and tried all that came up but wasn't successful there either. I have the DB9 cabled connected to a usb to serial adapter (I know it works, I've used it on my switch recently), and the 3.5mm audio looking end into the jack on the front panel. I get some garbage in the console screen, so I know i'm in the right place, I just have the wrong settings.

1000001101000

  • Debian Wizard
  • El Toro
  • ****
  • Posts: 460
  • There's no problem so bad you cannot make it worse
Re: Serial settings for TS-RX4.0TL/R5?
« Reply #1 on: September 24, 2019, 06:18:54 pm »
The settings Iíve used are: 115200 8N1