Author Topic: LS-WX2.0TL/R1 - Function light flashes once and reboots  (Read 281 times)

Clarenford

  • Calf
  • *
  • Posts: 3
LS-WX2.0TL/R1 - Function light flashes once and reboots
« on: August 20, 2019, 10:48:54 am »
My unit just started doing this. Power on and sounds like it is booting(hear drives spinning) and then it stops, flashes a single red function light and reboots. It keeps doing that until turn off or unplugged.
Tried doing the hold function button for 10 seconds while turned off but, no change. I haven't found anything on the forums related to this issue.

1000001101000

  • Debian Wizard
  • El Toro
  • ****
  • Posts: 379
  • There's no problem so bad you cannot make it worse
Re: LS-WX2.0TL/R1 - Function light flashes once and reboots
« Reply #1 on: August 20, 2019, 11:36:33 am »
The manual lists the codes flashed by the led, it should give you some idea of what is going on.

Clarenford

  • Calf
  • *
  • Posts: 3
Re: LS-WX2.0TL/R1 - Function light flashes once and reboots
« Reply #2 on: August 20, 2019, 01:22:53 pm »
I didn't see any codes for the function light. It just gives me the one second red function led and reboots. No error/info codes.

1000001101000

  • Debian Wizard
  • El Toro
  • ****
  • Posts: 379
  • There's no problem so bad you cannot make it worse
Re: LS-WX2.0TL/R1 - Function light flashes once and reboots
« Reply #3 on: August 20, 2019, 02:08:43 pm »
hmm, how long does it take for that to happen?

If it's only a second or two I would think the power supply isn't providing enough power for the device to start booting.

what happens if you try it without any drives in it?

Clarenford

  • Calf
  • *
  • Posts: 3
Re: LS-WX2.0TL/R1 - Function light flashes once and reboots
« Reply #4 on: August 20, 2019, 02:34:08 pm »
That was it. Pulled the drives and it stayed on. Tried a different power supply with drives in and it's still running with no errors.

Thank you!