Author Topic: Terastation 410D 7 Red Blinking Lights  (Read 646 times)

  • Calf
  • *
  • Posts: 1
Terastation 410D 7 Red Blinking Lights
« on: May 03, 2019, 08:26:53 am »
Help!  My Terastation 410D is showing 7 blinking red lights after it boots up and I can't access it.  Looking at the manual it looks like it could be firmware?  But I can't connect to it to update, so how do I update, or how can I recover the data on the drive?  Any advice is appreciated.


  • Debian Wizard
  • Big Bull
  • *****
  • Posts: 801
  • There's no problem so bad you cannot make it worse
Re: Terastation 410D 7 Red Blinking Lights
« Reply #1 on: May 03, 2019, 08:56:05 am »
I'm assuming you mean the Linkstation ls410d, if not please correct me.

You can remove the drive from the device and connect it to a PC to recover the data and run diagnostics on the drive (hire a professional to do this if the data is sufficiently important). It's somewhat easier for the single-drive models because you don't have to worry about software raid.

You can:
remove the drive from the device
connect the drive to a pc either via usb adapter or directly
boot into a Linux live environment
mount the data partition and backup data as needed.
look at SMART data/run diagnostics to determine if the drive is failing.

I've got notes and pictures for how to take this device apart (it only requires one screw from behind the sticker on the bottom):

If you want to replace teh drive with a new one you can load the firmware with this procedure: