Author Topic: ts5400r how the image from usb is loaded  (Read 760 times)


  • Calf
  • *
  • Posts: 1
ts5400r how the image from usb is loaded
« on: February 15, 2019, 04:20:06 am »
The boot of my TS5400R device is broken. I downloaded the image of the usb, but I didn't find any documentation on how to install it.
I wonder if there is a source I can learn how to install.


  • Debian Wizard
  • Big Bull
  • *****
  • Posts: 801
  • There's no problem so bad you cannot make it worse
Re: ts5400r how the image from usb is loaded
« Reply #1 on: February 15, 2019, 08:00:58 am »
You can install the firmware by doing the following:

download the firmware updater for the device if you haven't already
insert your recovery disk
flip boot mode switch to "USB"
turn on the device, wait several minutes for it to finish booting into EM mode
enable debug mode for tsupdater:
use tsupdater to install the firmware.

**if you don't care about the data on the device you can use the re-partition/re-format options, otherwise you'll want to stick to just forcing a firmware install to try to recover with the data intact.