Products > Storage
How to fix a bad drive
silver_mica:
Howdy,
I have a Buffalo NAS drive with a red light. I believe it flashes three times. Now, I am not 100% sure of the model - but I believe it's the Buffalo LinkStation Pro Duo 2.
So, what do I do? Buy a hard drive and pop it in (replace the bad hard drive)? Or, is there a procedure for rebuilding?
NAS Navigator 2 has this to say:
Error:
E30: An error has occurred on disk 1
I12: The RAID array works under degrade mode
I also took a screen capture:
davo:
Buy a new disk, put it into whichever bay is show the fault, reboot the unit, log onto the setting page and rebuild the RAID.
silver_mica:
So, I take it I'd use NASNavigator to rebuild the RAID?
--- Quote from: davo on December 08, 2018, 05:48:32 PM ---Buy a new disk, put it into whichever bay is show the fault, reboot the unit, log onto the setting page and rebuild the RAID.
--- End quote ---
davo:
No, you do this via the settings page. System - Storage - Array1.
silver_mica:
I don't know of anyway to access a settings page. The only thing I know is that after plugging these NAS drives into the network they show up as a network drive (Windows Explorer). My units are pretty old - are the manuals still around somewhere?
Navigation
[0] Message Index
[#] Next page
Go to full version