I have a Linkstation LSWX2.0 NAS with firmware version 1.73 (DTCP-IP:1.65-20130731). The drive 1 failed with too many bad blocks. So I purchased the exact same model, DT01ACA100, as was in the unit and now when it comes up it still says "Error" under drive status when I view Storage under System in the web GUI.
I'm able to access the web GUI obviously, and I'm able to access the "info" share but no other shares allow access. From everything I've found it indicates I can just shove a new drive in there, with the power off of course, and it should do the rebuild automatically.
The info light on the front blinks one long and four short which as best I can tell from the documentation indicates "The RAID array is being checked."
1. What drive do I need?
2. Shouldn't I be able to access the data while it's in degraded mode?