Author Topic: TS-8VH24TL/R6EU - Format failed. Update Aborted.  (Read 4349 times)

finand

  • Calf
  • *
  • Posts: 1
TS-8VH24TL/R6EU - Format failed. Update Aborted.
« on: November 27, 2017, 07:54:36 AM »
Hi all,

I'm currently trying to revive my TeraStation (TS-8VH24TL/R6EU) after a year out of action as it appears to have a firmware issue and unfortunately I'm out of the warranty period. This comes on the back of my hard drives being stolen, so not exactly a lucky machine! Never the less, here's where I'm at:

Set-up:
- TS and laptop plugged into 5-port switch, switch connected to router (all wired), TS receiving DHCP address.
- USB recovery disk created, booting via USB mode (enabled on back). Unit boots to red screen "Welcome to TeraStation".
- 8 bays, 4 x 1TB & 4 x 750GB (not original disks, but checked and all working)

Steps taken:
- TS showing in NasNavigator2 with DHCP address and has detected that the unit is in it's recovery mode.
- Connected 8 hard drives to a desktop, used DISKPART and 'Clean' command to erase the disks before putting them into the TS.
- Have tried to install firmware 1.3, including rebuilding the partition table, delete-user config and force update - as outlined by the Buffalo PDF guide.

After a while of formatting, I receive the error 'Format failed. Update aborted'. When I initially run the firmware update, my TS shows up with it's information including IP address however the firmware doesn't have a version, it's simply showing as "---".

Also, I didn't think this would be an issue but can someone confirm if every drive has to be the exact same capacity? As I have 4 of one type, 4 of another - but in theory it should still work right?

Any guidance would be greatly appreciated!

https://imgur.com/n5oFdb9


https://imgur.com/tIpwQts

https://imgur.com/lqG6HSY

https://imgur.com/j3CsUqc
« Last Edit: November 27, 2017, 08:17:33 AM by finand »

ctfields

  • Calf
  • *
  • Posts: 4
Re: TS-8VH24TL/R6EU - Format failed. Update Aborted.
« Reply #1 on: April 07, 2019, 09:41:28 PM »
Good day,
Did you ever find a resolution to this?  I am having similar problems with the Format failed, update aborted and my setup is very similar to yours, thanks!

oxygen8

  • The Oxy-genuine article
  • El Toro
  • ****
  • Posts: 417
  • Giving you some breathing space.
Re: TS-8VH24TL/R6EU - Format failed. Update Aborted.
« Reply #2 on: April 08, 2019, 12:39:05 AM »
Edit the TSUpdater.ini and try again

VersionCheck = 0
NoFormatting = 0

[SpecialFlags]
Debug = 1

ctfields

  • Calf
  • *
  • Posts: 4
Re: TS-8VH24TL/R6EU - Format failed. Update Aborted.
« Reply #3 on: April 08, 2019, 07:17:01 AM »
Thanks for the tip, I have edited mine and it looks just like that except no formatting is set at 1.  I am afraid if I set it to a 0 all of my data will be lost.  Can anyone confirm that with it set as a 0 it will not erase data?

oxygen8

  • The Oxy-genuine article
  • El Toro
  • ****
  • Posts: 417
  • Giving you some breathing space.
Re: TS-8VH24TL/R6EU - Format failed. Update Aborted.
« Reply #4 on: April 08, 2019, 01:55:38 PM »
It will erase all data!