Author Topic: LS-WVL/R1 Series how to retrieve data  (Read 340 times)

peaveyyyy

  • Calf
  • *
  • Posts: 3
LS-WVL/R1 Series how to retrieve data
« on: December 14, 2016, 04:58:59 am »
Hi

I am getting this from my LinkStation:

Error:
E14: Cannot mount RAID array 1. (2016/12/14 17:09:47)
E30: Drive 2 error. Replace the drive immediately! (2016/12/14 17:08:25)
Status:
I11: Drive 2 has too many bad sectors. (2016/12/14 17:08:43)

Do I simply replace the drive 2 and then it all works again?

davo

  • Really Big Bull
  • VIP
  • *
  • Posts: 5556
Re: LS-WVL/R1 Series how to retrieve data
« Reply #1 on: December 14, 2016, 10:06:05 am »
You left the unit in RAID0 and a disk has failed, you cannot rebuild the RAID as the RAID no longer exists.

I hope you had a backup as your data is gone.
PM me for TFTP / Boot Images / LSRecovery.exe file.

peaveyyyy

  • Calf
  • *
  • Posts: 3
Re: LS-WVL/R1 Series how to retrieve data
« Reply #2 on: December 14, 2016, 10:28:30 am »
Thanks for the reply.

How can you tell it was in Raid0?

davo

  • Really Big Bull
  • VIP
  • *
  • Posts: 5556
Re: LS-WVL/R1 Series how to retrieve data
« Reply #3 on: December 14, 2016, 10:35:08 am »
Because of the errors you have, if you had RAID1 then you wouldn't have E14.
PM me for TFTP / Boot Images / LSRecovery.exe file.