Im new to this place so excuse me if the question is easy.
I have a Ls 220DE that worked fine, then one drive did fail. I tried to restore, but no luck.
also
I noticed it was in emergency mode while working on it, but followed a post for a cure and it came back
I got 2 new drives (Both matched brand and size ) put both in went trough setup. At the end of setup when i went to configure though browser, it recognized only one of the 2 drives.
(It reads the other as disconnected.)I tried to rerun setup again It will not see it still
Should I try ..
And go through setup using only the non working drive?
Erase non working new drive in windows- remove partitions if any.. and try again? (this might cause issues returning drive but ill probably keep it)
Buy another drive to see if the the new non working is bad?
I also wonder if the side ( number 2 slot) where the non working drive is plugged into is not working itself..
Any and all help appreciated.
This might be in the forum somewhere but i could not find it,
Thanks ahead of time.
