I have a LinkStation with two 1 TB drives set up in RAID 1. It's a little less than 2 years old and I'm not having any problems with it. However, when I looked at the admin page this weekend I noticed that under System > Storage, down under RAID Array the "Status" of Array 1 is "Error." Not sure what this means since, as I stated, I'm not having any problems that I know of. The drive is about 60% full. I did run Check Disk, and it does not report any problems. I then chose to rebuild the array, which didn't take that long. Then the Error was gone for a while. But I rechecked later the same day and the "Error" is back in the Status column. I am just mildly concerned that there is something unhealthy about the drive. Should I be concerned? Is there something I should do?