Hello,
I have a problem with my Terastation ( HD-H1.0TGL/R5) after trying to update the Firmware from 1.x to 2.0.
After turning on the TS the blue LED will go on indicating Gigabit ethernet, the green LED in the middle will blink constantly and the green LED for the drives will flash circling clockwise. After about a minute, the green LEDs for the drives are still circling, I am able to access the drive through the network, I am not running a DHCP server but I am able to access it on 192.168.11.150. I am able to fully access the website at this point, doing a reset or enabling shares.
After a couple of minutes, the drive LEDs were still circling up to this point, the drives will shut down, the drive LEDs will switch to solid green and the left LED of the buttom 3 will flash 6 Times red over and over. The TS is no more accessible at this point.
I tried to update the firmware again using the executables for version 2.0 and 2.16 but the updater program will not find the TeraStation and say "Terastation that needs updating wasn't found", note that I am able to ping and access the website of the TS at this point though. Also the NasNavi cannot find the TS.
I have also tried TFTP Boot Recovery TS-HTGL-R5 1.20 by changing my Computers IP to 192.168.11.1 and starting the program. It will correctly say that it is listening on 192.168.11.1 and that it is accepting requests but nothing else happens. I tried resetting the unit by pressing the red reset button on the back for over 30 seconds but nothing happens.
Because the TS is accessible for at least a couple of minutes until it shuts down and flashes the red LED I am still hoping to be able to recover the unit. So what should I do?
Thanks for your replies in advance.