General config:
Devices:
Modem, 2x N600 (N600a and N600b for our purposes), Laptop
Modem <--WAN> N600a <LAN--LAN> N600b <LAN--LAN> Laptop
I have configured N600b based on the configuration outlined in the user manual and the following is the result:
N600a: 192.168.11.1 (static)
N600b: 192.168.11.250 (static)
Laptop: 192.168.11.X (dynamic)
(I am currently writing this from the laptop so the routing in general is currently working correctly)
My current issue is once I upgraded N600a to the latest firmware I'm no longer able to access N600b's web GUI. Everytime I enter the address 192.168.11.250 into my address bar it redirects me to 192.168.11.1 (primary router) and won't let me access anything else.
I am able to ping 192.168.11.250:
PING 192.168.11.250 (192.168.11.250): 56 data bytes
64 bytes from 192.168.11.250: icmp_seq=0 ttl=64 time=0.281 ms
And CURL requesting
http://192.168.11.250 shows a redirect header:
$ curl -i http://192.168.11.250
HTTP/1.0 302 Found
Content-Type:
Server: httpd
Date: Thu, 11 Jul 2013 00:28:00 GMT
Connection: close
Cache-Control: no-store, no-cache, must-revalidate
Cache-Control: post-check=0, pre-check=0
Pragma: no-cache
Location: http://192.168.11.1/detect.asp
Disconnecting the link from N600a to N600b and setting a static IP on the laptop in the correct subnet allows me to still ping the N600b router but I cannot access the GUI a it's likely attempting to access the primary N600a router.
Any help / tips / thoughts would be helpful.
Things to remember:
- I could access the gui for N600b PRIOR to the latest firmware was installed on N600a.
- Umm.... not sure what else to remember