Author Topic: How to set up WHR-HP-G300N as a repeater  (Read 3555 times)

ngovanhinh

  • Calf
  • *
  • Posts: 5
How to set up WHR-HP-G300N as a repeater
« on: October 19, 2012, 10:34:42 PM »
I want to set up my WHR-HP-G300N as a repeater as follow: AP (with wpa2 on) --wirelessly- -> my WHR-HP-G300N --wirelessly--> my computer. Could anyone help me please?

realborat

  • Buffalo
  • ***
  • Posts: 223

ngovanhinh

  • Calf
  • *
  • Posts: 5
Re: How to set up WHR-HP-G300N as a repeater
« Reply #2 on: October 22, 2012, 08:00:33 AM »

I have set up the system as instructed, including setting security mode same as that of the AP, and my buffalo router is sucessfully connected to the AP, but my computer fails to receive internet signal from the router, unless disabling the AP's security/encryption, i.e leaving it open without WEP or WPA on.


realborat

  • Buffalo
  • ***
  • Posts: 223
Re: How to set up WHR-HP-G300N as a repeater
« Reply #3 on: October 24, 2012, 03:25:55 AM »

 

Two different procedure are described on the link I sent you,

Which one did you use? 

Wireless Bridge Link

WDS setup


ngovanhinh

  • Calf
  • *
  • Posts: 5
Re: How to set up WHR-HP-G300N as a repeater
« Reply #4 on: October 24, 2012, 09:48:25 PM »

Dear Realborat

 

I use the first one, wireless bridge link. After setup, under Status-Wireless-Wireless Nodes I also see the presence of the AP. But my computer still cannot access the internet. By the way, my computer is connected to G300N router through the LAN cable.