iN RESPONSE TO THE lan LOOP issue
This morning at one of eight camea locations
The BUFFALO WBMR-HP-GNV2 - router shows RED light on INTERNET CONNECTION
WBMR-HP-GNV2 -
SIMPLE REPAIR DISCONNECT POWER FROM BUFFALO WBMR-HP-GNV2 router
reconnect power to BUFFALO WBMR-HP-GNV2 -
Everything BOOT UP BACK TO NORMAL
There is nothing on the EIGHT BUFFALO WBMR-HP-GNV2 ROUTER LAN other than IPcamera connection... This error is the FIRMWARE TROUBLE that was NEGLETED, UNTESTED by the
BUFFALO quality control software...
The IPcamera operated this time three days with no error.... After three days THIS IP camera location was down... The Buffalo Router disconnected from the INTERNET.. IT SHOW A RED LIGHT
for INTERNET... A simple power RESET only to the BUFFALO ROUTER repaired the problem..
IS IT TOO MUCH OF A PROBLEM TO CODE W_A_T_C_H_D_O_G routine into the
firmware to RESET the BUFFALO router ????
THE IP CAMERAS EIGHT BUFFALO ROUTERS USE DDNS SERVICES TO HOLD A WAN IP
LOOK UP... The BUFFALO ROUTER HAS DEFFECTIVE CODE... To make this three day test the NIST TIME look up was DISABLED and DHCP lease time was SET 9999...
JAPAN must wake up to the FACTS the time delays inside the FIRMWARE are no good... The
quality monitor of LAN traffic is not available to stop ERRORS
UNDER ALL CONDITIONS OF GOOD LAN ATTACHED WORKING HARDWARE
A ROUTER SHOULD NEVER KILL THE LAN FREEZE THE INTERNET NO EXCUSES
THE LAN HARDWARE MUST STAY OPEN ACTIVE ON ALL PORTS AS MULTIPLEXED
THE PORTS MUST STAY ACTIVE SCANNED NEVER FREEZE UP
BUFFALO ROUTER NO GOOD FREEZES UNDER SOFTWARE DELAYS
CAN NOT RESET THERE IS NO WATCHDOG SOFTWARE MONITOR