Author Topic: wzr-ag300nh DHCP server not found  (Read 3086 times)

ad4834

  • Calf
  • *
  • Posts: 1
wzr-ag300nh DHCP server not found
« on: January 30, 2009, 07:28:57 pm »
   I can access the router config but trying automatic wireless setup, I receive an error message from what, DHCP Server or PPPoE Server not found!... I've trying resseting to factory on the back of the router and through Web page, with the same result.  I'm detecting it and the signal is perfect but... no DHCP .  On the back of the router my switch (AP/Router) is on router.  I did try pressing AOSS on the router until it starts flashing and pressing AOSS button inside the software within 2 minutes, but again nothing.  I do a scan and it's dectecting it but no access to internet!...

Paul

  • Big Bull
  • *****
  • Posts: 1223
Re: wzr-ag300nh DHCP server not found
« Reply #1 on: February 02, 2009, 10:10:24 am »
This means the device is not is not seeing the modem.  You can clone the mac address and power cycle both devices.

Colin137

  • Big Bull
  • *****
  • Posts: 1125
Re: wzr-ag300nh DHCP server not found
« Reply #2 on: February 05, 2009, 10:05:36 am »
Many modems hold on to the MAC (or Physical) address of the device last connected to it. Reset the modem to clear this cache, you can do this if there is a reset button on the modem, or simply by powering the modem off for at least 5 minutes, then as Paul suggested, power cycle the router. This should allow the router to obtain an address through the modem.