Buffalo provides Data Recovery services. Read about it here.
Hi,
waiting for a solution to bridge two WHR-G300N (if there will ever get one) I bought another buffalo product, the WLI-TX4-AG300N Ver.1.52 (R1.03/B1.02). Now, I cannot get it to connect with the WHR-G300N at 2x 40Mhz mode, and even in 1x mode, there is a strange behaviour. The diagnostic page shows my connection as 60%(104 mbps) when i'm not transmitting or receiving anything and the same moment I start to transfer a file, it drops at 19Mbps or the like. It's like the real speed is only showed when there is real traffic to allow the measure. And 19Mbs is low for a draft 2 device at 60% connection, isn't it? Is there something I'm doing wrong? Maybe there should be some specific settings to allow the full speed? Like having WPA2 instead of WPA like I read in another thread about another similar problem?
Thanks.
Sorry, I don't find wireless settings, only wireless config and ther is nothing like tx Burst Mode.
And I tried to switch channels, the client switches channel after I change it on the router, but always at 1x.
Maybe I don't have the latest firmware? But I cannot find my products on the download section. (http://www.buffalotech.com/support/downloads/) My firmware is WHR-G300N Ver.1.60 (R1.49/B1.09).
Maybe I must turn on router mode? (I'm in access point mode)
I really cannot understand what's going on :(
Is in my previous post, it's WHR-G300N Ver.1.60 (R1.49/B1.09)
I couldn't find another firmware on the support downloads.
Today I made more test with channel switching. The client switch channel according to the access point but never shows 2x in the connection info.