Author Topic: "No Init File At HDD 3"  (Read 3018 times)

Aleksiv95

  • Calf
  • *
  • Posts: 7
"No Init File At HDD 3"
« on: May 03, 2013, 09:34:22 am »

Hi everyone!

 

I have a TeraStation ES 4TB model that shows "No Init File At HDD 3" on startup. The device doesn't show the error light and the message is only shown very briefly on startup, but I don't know what it means or if it's important or serious. Does anyone have any suggestions?

 

Aleksi


DiC

  • Calf
  • *
  • Posts: 3
Re: "No Init File At HDD 3"
« Reply #1 on: November 12, 2017, 04:40:28 am »
Hi,
I have terastation 3400 with 4 disk in Raid 5 .
I switch off Nas (push 3 sec Power button) for change UPS
When i restanti It  at startup Nas show "no init file at hdd 3"
I can't see Nas in my internet.
Help me!

Eastmarch

  • 1500 Lb Water Buffalo
  • Administrator
  • *****
  • Posts: 257
Re: "No Init File At HDD 3"
« Reply #2 on: November 13, 2017, 02:05:02 pm »
Try booting the system with drive 3 out.
**A single copy of data, even on a RAID array, is NOT a backup! Hard drive failure is not a question of IF, but WHEN! Don't take my word for it, take Google's!**

DiC

  • Calf
  • *
  • Posts: 3
Re: "No Init File At HDD 3"
« Reply #3 on: November 13, 2017, 10:31:52 pm »
in this state Nas not permit any action.
But yesterday it finish booting (never see on lan )  and display show info i41 code than i try recovery (push function button ) but it fail.
Now i contact assistance , operator tell me same soluction ,
turn off
ectract hdd3
restart
show this message
no init file at hhd 3
no init file at hhd 1
no init file at hhd 2
nand boot
error (red display )
try recovery but fail.
dislay now blue , firmware version not showed  , no error led lamp , no lan parameter lost.
Assistance send me  usb boot procedure for  recovery , today i try i hope recover data !

DiC

  • Calf
  • *
  • Posts: 3
Re: "No Init File At HDD 3"
« Reply #4 on: November 14, 2017, 09:31:34 am »
USB boot done but recovery failed !
Now try control any hdd
can suggest correct metod ?

i think put off one hdd,
with cristal disk app control by my win10 pc
it's correct ?