Hi All,
I have LS-WXL NAS and I'm facing E06 error.
I do not know how to get rid of it. It apeared after power failure.
I tried to boot it up in EM and uploaded new firmware but everytime after reboot E06 appeared.
I removed all partitions from WD Green Caviars (1TB), checked the hard drives using WD software (S.M.A.R.T & bad sectors) and there were no faults found.
I updated LSUpdater.ini to state:
[Flags]
VersionCheck = 0
NoFormatting = 0
[SpecialFlags]
Debug = 1
?
ticked on all boxes in debug mode and tried upload the firmware again. HDDs were formated successfully NAS rebooted and displayed E06 again.
NAS is fairly new, but I cannot find the recipt so cannot prove that waranty is still valid.
Any ideas how to solve the problem?
Regards,
Most of the time power failures causes E06. UPS are really necessary.
You are in the right direction, but you have to follow instructions carefully.
You have to TFTP boot two times. The first time, the drives are formatted and the second time the firmware is copied.
Check this
Thank you for the solution. It works!
Thanks for the link, selecting ONLY recreate the partition table in the firmware utility finally did it. My E06 is caused , and full reproducable, by trying to switch to RAID-1 on an LS-WXL.
HI, I have the same issue.... so what the heck good is a NAS when you can't do RAID-1? Mine has done this 2x, not reliable in my opinion.