Hello,
I have USB and Esata connection so no web interface.
The soft ware with unit is raid setup utility.
I see no other software.
The drive is seen in windows ,
Anyways I see no diagnostic utility so I post here. The Red light is flashing on #4 (rebuild I guess)
When I run raid setup utility (because its the only thing given) and I hit information it says rebuilding disk 4 50% it said 52% and 5 hours later %50 again.
Checked again now %50.
When I explore to drive I can see it, but it appears "some" contents are missing, or at least "corrupt".
I try to run disk check in windows but after a minute or 2 it says can not run...
So is drive failed? If failed why does it say rebuilding? Why stuck at %50? Is there a utility that checks the drive?
Since I only have USB is there a Linux kernel? How do I see that? If not how do I see firmware?
Need some more software or help...
Thanks
Vis.