Buffalo Forums
Products => Storage => : rainsun July 24, 2018, 02:26:05 PM
-
Product Part: LS420D0402-EU
Serial Number: 80059434501887
Description: LS420D NAS Raid0 Array Failed
Problem Details: cannot mount Raid array
always shows checking
Steps taken:
- Check disk on array 1 - no result
- reboot - no result
- firmware upgrade - no result
Somebody help me! The data is really important!
Thanks in advance!
(http://rasinwp.qiniudn.com/nas1.jpg)
(http://rasinwp.qiniudn.com/nas2.jpg)
(http://rasinwp.qiniudn.com/nas3.jpg)
(http://rasinwp.qiniudn.com/nas4.jpg)
-
RAID0 and no backup?
-
Yes ...
The data is not created by me... It has been years and nobody touches the NAS
Unfortunately, I have to use the data now... Could you give me some advice?
Thank you very much!!
-
You're either looking at a RAID failure (yes it does happen) or bad sectors on one of the disks. Eitherway, if you need the data it would be best to contact a recovery company.
-
Will the buffalo built-in RAID check helpful? I only have 2 * 2T hard disks but it has already 4 days...
Shall i stop or let it keep on checking?
-
After 4 days I'd imagine it will not finish.