Buffalo Forums
Products => Storage => : Legintoof March 19, 2017, 06:54:21 AM
-
Hi all, Long story short - I reinstalled the firmware version 1.71 to try and reset LS-WRXL/R1 Series and now disk 1 of 2 is saying its "Removed". Is there a way to recover Disk 1? Is all the data lost now?
Any advise on if this is fixable would be appreciated.
-
What RAID mode were you using?
-
Thanks for you reply Davo, I'm not actually sure what the drives were set to use before hand. Now it seems that the linkstation is seeing both drives and Drive 2 I has the option buttons active but Drive one is selectable but the option buttons are not active and the Array is "Not Configured" and I'm assuming that Drive 1 may have different Array information maybe??