Buffalo Forums
General => Guidelines and more => : BigBird0000 January 13, 2015, 11:16:51 PM
-
When I open up NasNavigator2, I get
"Status:
Emergency mode. Update the firmware or contact technical support. (2015/01/11 16:47:23)"
Trying to update firmware using LSUpdater FW 1.69, I get the message partition not found - aborting upgrade
In the LinkStation, I put a single 2TB hard drive (led status-green)
How do I format the disk and update the firmware (or Vice Versa)
-
You will have to format the disk with the LSUpdater. If you dont have your data backup i suggest getting a company to do so. If you do then go to http://m1econsulting.com/knowledge-base/force-update-buffalo-linkstation-nas/ and you follow Newer Models part and set "noformatting" to 0 instead of 1
-
so I've tried the firmware updater and now my drive is flashing red 6 times.
not sure how to get past this.