Buffalo Forums
Products => Storage => : haloway13 November 04, 2013, 06:43:25 PM
-
After rebooting the NAS I get a cannot mount error, I check the array through the web console, it fixes the problem but does not clear the error from the display.
Everytime I reboot this happens appears dead until I check the array, appears fixed but does not clear from the units display(shows red and the error).
I have tried:
rebuilding array and restoring from backup
restore the nas (all kinds of settings are lost and should be noted, webaccess key, groups etc)
Firmware is 1.59
Any ideas?
-
What kind of additional information would be helpful to diagnose the issue?